Diverter V4000

Design

• Round diverter pan with 2 to 12 discharge sockets
• Transparent cover in acrylic glass (PMMA)
• Brushless electric motor built into diverter holder
• Power fail-safe position monitoring
• Construction according to GMP specifications
• Integrated in CU combined unit with deduster and with or without metal detector
• As stand-alone product diverter on roll-away stand
• The diverter is controlled either by the controller C920 or optionally directly by the tablet press (requires press software modification)

Control modes

• Mode A - Container level control A sensor monitors the level of each container. When a preset level is reached, the switch moves to the next position. All monitoring and other signals are processed in the controller C920 (Independent operation)
• Mode B - Press generates signal The press outputs a signal (time based or tablet number based) over a zero-voltage relay to the controller C920 which in turn commands the distribution switch into the next position. The monitoring is performed by the controller C920 (Signal from press required)
• Mode C - Press outputs impulses The press outputs impulses over a zero-voltage relay to the controller C920 which counts them. The switch moves to the next position when count reaches a preset number (Signal from press required)
• Mode D - Preset container barreling time Barreling time is entered into the controller C920 independently from the press. The switch moves to the next position when the preset time is up. All monitoring and other signals are processed in the controller C920 (Independent operation)

Versions

• Model V4000 - round ø60mm connections on the outlets Inlet and outlet

Inlet and outlet

• Round inlet tube with 30° inclination
• Hoses in PU/KM (required inclination min. 45°)
• Stainles steel tube outlets (needed if inclination is less than 45°)

Options

• Jam sensor - capacitive proximity switch PNP / NC in the inlet tube
• CAN Bus interface
• Profi Bus interface
• Validation documents