TDA-100A Automatic Filter Tester
Source: AIR Techniques International
The TDA-100A Automatic Filter Tester utilizes state-of-the-art technology and microprocessor control
The TDA-100A Automatic Filter Tester utilizes state-of-the-art technology and microprocessor control. The design features a user friendly interface to minimize setup and operator training. All functions and operating parameters of the machine can be programmed using just 4 function keys and the menus are shown on an easy-to-read, alphanumeric LCD dsiplay.
Features
The test parameters for Percent Penetration, Filter Resistance and Filter Test Flow are shown on individual digital display panels. All three test parameters have individually adjustable alarm set points which are continuously monitored by microprocessor. Should a parameter exceed its set point, the FAIL light will illuminate and the parameter's digital display will flash. Testing will not be permitted until the unit is reset. The microprocessor self-checks the system during operation and the FAULT light alerts the operator to any system faults. The specific problem causing the fault is identified on the LCD display. The monodispersed aerosol is also microprocessor controlled allowing fully automatic, unattended operation when integrated into an automatic production line. The TDA-100A Automatic Filter Tester is housed in a modern, roll-around cabinet. This unit features an ergonomic front control panel position for sit-down operation. The TDA-100A has safety features on its universal test fixture designed to accommodate any canister filter manufactured today and in the future. An RS-232 port on the TDA-100A gives the capability of data collection for SPC purposes and control of the machine by remote PC.
The test parameters for Percent Penetration, Filter Resistance and Filter Test Flow are shown on individual digital display panels. All three test parameters have individually adjustable alarm set points which are continuously monitored by microprocessor. Should a parameter exceed its set point, the FAIL light will illuminate and the parameter's digital display will flash. Testing will not be permitted until the unit is reset. The microprocessor self-checks the system during operation and the FAULT light alerts the operator to any system faults. The specific problem causing the fault is identified on the LCD display. The monodispersed aerosol is also microprocessor controlled allowing fully automatic, unattended operation when integrated into an automatic production line. The TDA-100A Automatic Filter Tester is housed in a modern, roll-around cabinet. This unit features an ergonomic front control panel position for sit-down operation. The TDA-100A has safety features on its universal test fixture designed to accommodate any canister filter manufactured today and in the future. An RS-232 port on the TDA-100A gives the capability of data collection for SPC purposes and control of the machine by remote PC.
AIR Techniques International, 11403 Cronridge Dr., Owings Mills, MD 21117. Tel: 410-363-9696; Fax: 410-363-9695.